In all walks of life, measuring peristaltic pumps are usually used to accurately transfer liquids because it is pollution-free. There are many advantages such as high precision and good sealing, so the sales of this pump is also very good, more people use it, the corresponding use problems also follow, there are many customers just use this pump, there are always some wrong operation, the following Purui fluid for you to explain the use of pump skills.

To measure the composition and function of peristaltic pump

The pump consists of three parts of the drive. Peristaltic pump head and hose. The principle is through the roller in the pump head extrusion hose, so that the hose inlet for negative pressure, so that the liquid filled pipeline transmission. The whole pump uses the LCD screen display, the image is intuitive, equipped with a touch screen, key operation, flow and time mode, to bring good experience for users.

Measuring the use of peristaltic pump skills

1. When using a new pump, it is recommended to check first and then, mainly to check the integrity of the appearance and whether the accessories are lost.

2. Test according to the product specification, not for guessing. Since the pump is constantly improving, reading the instructions helps to master the pump faster.

3. If the pump needs to be used outdoors, it is necessary to add a protective cover on the pump, because rain wet the drive may cause short circuit.

4. Silicone tube can be used for peristaltic pump hose, but special amount liquid needs special hose, can not be generalized.

5. When the pump stops using, please add some lubricating oil to the bearing part for next use.

6. The service life of the pump pipe can be extended by loosening the pressure pipe block when not working. The pump delivers the fluid by squeezing the hose and the rebound of the hose itself to create suction. In order to maintain the long life of the pump tube, when the pump is not used, try to lift the pump head block, so that the pump tube is in a natural pressure free state, thus extending the service life of the pump tube.

7. After the pump works for a long time, check the wear condition of the hose to avoid the wear leakage and loss of the pipeline.

8. The inlet of the pipe shall be as short as possible, and the joint and diameter of the pipe shall not be lower than the diameter of the stuck pipe installed in the pump head. The suction of the pump is caused by the rebound of the pump pipe. If the pipe, especially the inlet pipe is too long or too small, the suction end resistance is too large, the resistance is too large to block the rebound of the pump pipe, the actual flow loss is great (can be used with countersunk head). On the contrary, because the discharge pressure of the pump is usually small, when the discharge resistance is too large, the output flow will be reduced.

The above content is "Metering peristaltic pump use tips" If you have any needs and related questions about the metering pump, you can call Prefluid.