In all walks of life, measuring peristaltic pumps are often used to precisely transfer liquids because it is non-polluting. High precision. Good sealing and many other advantages, so the sales of this pump is also very good, more people use, the corresponding use problems also follow, there are many customers just use this pump, there are always some wrong operation, the following Purui fluid to explain the use of pump skills for you.
Measurement of peristaltic pump composition and function
The pump consists of three parts of the drive. Peristaltic pump head and hose. The principle is to squeeze the hose through the roller in the pump head, so that the hose inlet is negative pressure, so that the liquid is filled with the pipeline for transmission. The whole pump adopts LCD screen display, the image is intuitive, equipped with touch screen, key operation, flow and time working mode, to bring good experience to users.
Measuring the use of peristaltic pump skills
1. When using a new pump, it is recommended to check first and then check, mainly to check the integrity of the appearance and whether the accessories are lost.
2. Test according to the product instructions and cannot be used for guessing. Since the pump is constantly improving, reading the instructions will help you master the pump faster.
3. If the pump needs to be used outdoors, it is necessary to add a protective cover on the pump, because rain wet the drive may cause short circuit.
4. Silicone tube can be used for peristaltic pump hose, but special liquid needs special hose, can not be generalized.
5. When the pump stops using, please add some lubricating oil to the bearing part for next use.
6. Loosening the pressure block when not working can extend the service life of the pump tube. The pump delivers the fluid by squeezing the hose and the rebound of the hose itself to create suction. In order to maintain the long life of the pump tube, when the pump is not used, the pump head block is lifted as far as possible, so that the pump tube is in a natural pressure-free state, thus extending the service life of the pump tube.
7. After the pump works for a long time, check the wear of the hose to avoid the wear leakage and loss of the pipeline.
8. The inlet of the pipe shall be as short as possible, and the joint and diameter of the pipe shall not be lower than the diameter of the stuck pipe installed in the pump head. The suction of the pump is caused by the rebound of the pump pipe. If the pipe, especially the inlet pipe is too long or too small, the suction end resistance is too large, the resistance is too large to block the rebound of the pump pipe, and the actual flow loss is very large (can be used with the countersink). On the contrary, since the discharge pressure of the pump is usually small, the output flow rate will be reduced when the discharge resistance is too large.
The above content is "The use of metered peristaltic pump tips" If you have any needs and related questions about the metered pump, you can call Pruy Fluid.