The use of peristaltic pump will affect the service life of peristaltic pump to a certain extent, in order to extend the service life of peristaltic pump, how to use peristaltic pump? The new peristaltic pump should be tested before use, because it will be damaged to a certain extent during transportation, affecting the test results, so before the test, let it sit for 3-5 hours, and then test, check whether the appearance of the peristaltic pump is damaged before the test, and then test according to the instructions after the check.
The outdoor environment is harsh, which will affect the service life of the peristaltic pump, so you should try not to place the peristaltic pump outdoors, if you must use it outdoors, use something to shield it to avoid wind and rain.
Peristaltic pump pump tube selection, if it is used for experiments, you can use the whole meter tube, if it is used in production, the health level requirements are not high, you can use ordinary tubes, which can effectively extend the service life of the pump tube, but also reduce the cost of the enterprise. If the production enterprise needs to use 24 hours a day, the appropriate feed pipe should be selected, because its service life will be longer than the ordinary pipe.
If the interval time of the peristaltic pump is relatively long, when you want to use each time, you should first add some lubricating oil to the internal shaft of the pump head to play the role of lubrication. The selected lubricating oil can be as long as it is oil.
In order to improve accuracy, each time the pump tube is pressed into the peristaltic pump pump head, the pump tube can be appropriately pulled to the left and right sides. The multi-channel peristaltic pump can first press the pump tube into the peristaltic pump pump head, and then pull the pump tube to the left and right sides appropriately, and then adjust the length of the left and right sides of the tube of each channel pump head to be consistent, so as to effectively reduce the error between channels.
When using a peristaltic pump, if the number of revolutions shown is always changing, it may be that there is magnetic interference around the peristaltic pump, put it elsewhere to restart the use. When measuring and distributing products, after all the relevant parameters are set according to the instructions, the pump will automatically run, the peristaltic pump tube can be moved by manual operation, and can also be used on the conveyor belt to achieve fully automated operation, so that the operation will not only reduce costs, but also improve accuracy.